This tutorial will demonstrate how to remove the PCB from the Cradlepoint CBA850.
This will allow an easier installation into a smaller sized enclosures as well as to provide optimal cooling to the components.
The second part of the tutorial will also show how to remove the metal cover off the MC400 to gain the cooling component as well.
There are many ways to mount and configure the CBA850 in an external Antenna and/or Enclosure. This is one example of using only the PCB.
WARNING: When connecting external antennas to the CBA850's modem, DO NOT over-tighten the coax cable's SMA connectors. Over-tightening can and will detach the connector from where it is soldered to the modem's PCB--which is not covered under warranty.
To remove the router PCB, turn the router upside down and remove the four adhesive rubber plugs using a small screwdriver.
Using a T6 Torx Driver, remove the four screws.
Open and separate the two halves of the router case.
Using a flat head screwdriver, gently lift and remove the PCB from the case.
While not required, I personally prefer to shorten the height of the reset button.
I also prefer to remove the white switch extensions but squeezing the lower parts together and removing from the slots in the PCB. I also slide the power switch to the 25W positioning.
One other suggestion is to record the CBA850's default password onto the PCB. This will be handy in the event the router is reset to factory default settings, and the router case (which contains the default password) has been misplaced.
Cradlepoint CBA850LP6 - Removing the PCB for Enclosure Installations
Forum rules
This forum is for tutorials only--not for help or assistance.
This forum is for tutorials only--not for help or assistance.
- JimHelms
- Site Admin
- Posts: 1366
- Joined: Tue Dec 19, 2017 8:59 pm
- Location: DFW Texas
- Has thanked: 79 times
- Been thanked: 199 times
- Contact:
Cradlepoint CBA850LP6 - Removing the PCB for Enclosure Installations
You do not have the required permissions to view the files attached to this post.
- JimHelms
- Site Admin
- Posts: 1366
- Joined: Tue Dec 19, 2017 8:59 pm
- Location: DFW Texas
- Has thanked: 79 times
- Been thanked: 199 times
- Contact:
Re: Cradlepoint CBA850LP6 - Removing the PCB for Enclosure Installations
When installing the MC400 modem in an external enclosure or antenna, it is recommended to remove the outer metal cover for optimal cooling. This is easily accomplished by removing the two screws on the bottom side of the MC400 and sliding the outer case off over the antenna connectors.
The screw hole also provides a good location for connecting a ground wire to the system.
WARNING: When connecting external antennas to the CBA850's modem, DO NOT over-tighten the coax cable's SMA connectors. Over-tightening can and will detach the connector from where it is soldered to the modem's PCB--which is not covered under warranty.
The screw hole also provides a good location for connecting a ground wire to the system.
WARNING: When connecting external antennas to the CBA850's modem, DO NOT over-tighten the coax cable's SMA connectors. Over-tightening can and will detach the connector from where it is soldered to the modem's PCB--which is not covered under warranty.
You do not have the required permissions to view the files attached to this post.