I have a WG3526 w/Calyx and would like to set it up with 2 omni directional antennas. I saw on the FB group that some people had a good experience using 2 of these antennas https://thewirelesshaven.com/shop/antennas/outdoo ... l-antenna/
What kind of cables and connectors would I need to run from the router to the antennas?
Also wondering about the best mounting kit for a pair of these.
Thanks!
Correct Cables/Connectors for Omni Directional Antenna on WG3526
Forum rules
Use the SEARCH function for related issues PRIOR to posting for assistance.
Use the SEARCH function for related issues PRIOR to posting for assistance.
-
shroudedninja
- Posts: 6
- Joined: Tue Apr 17, 2018 12:22 am
- Has thanked: 0
- Been thanked: 1 time
-
JimHelms
- Site Admin
- Posts: 1366
- Joined: Tue Dec 19, 2017 8:59 pm
- Location: DFW Texas
- Has thanked: 79 times
- Been thanked: 199 times
- Contact:
Re: Correct Cables/Connectors for Omni Directional Antenna on WG3526
The antennas have N female connectors. You will require low loss 50 ohm coax cables (i.e., LMR200, LMR400...depending on distance) with Type N Male connectors for the antenna, and Type N Male or SMA Male on the router end.shroudedninja wrote: Tue Apr 17, 2018 10:32 am
What kind of cables and connectors would I need to run from the router to the antennas?
The low loss cables are stiff and hard to work with at the router end. You should consider using Type N Male connectors on both ends of the cables and get a short (i.e., 10"...20") Type N female to SMA Male right angle (90 degree) RG58U jumper cable. This will allow more flexibility in coupling the LRM200/400 cable to the router.
The right angle SMA connector is best used where the router's 4G LTE antenna connectors are located on each side of the router (as opposed to both on one side or the back).
The antennas come with a mounting bracket and U bolts for mask or pole mounting. When using two for MIMO installations, you may consider using two satellite masks mounted side by side. They are pretty common and easy to locate.Also wondering about the best mounting kit for a pair of these.
