EM12-2 router and nexq6go connection problems

[scoTTcoM]

I bought a em12-g modem and a nexq6go router and the router sees the modem but wont connect to a page plus sim that works fine in a mr1100 and a mofi 4500, changed the com ports to usb 1 and 2 and set ttl to 64,65, 117 used apn for pageplus
nothing works ran at signal command getting 22 , 99 . It sees the sim getting my telephone number etc but just wont connect ,
Please Help.

[bjames]

You do not need to change your COM port with the EM12-G with the WiFiX firmware. In fact, you can disrupt its ability to properly communicate with the AT command COM port.

I would go to the Firmware Backup/Restore, and set the WiFiX firmware to its defaults settings.

Then, when it booted back up, set the APN (Save and Apply) and the TimeZone, and hard reboot the router.

While I am not familiar with pageplus, resetting the firmware would be my initial starting point.

[Didneywhorl]

PagePlus, in my limited experience, isnt super thrilled about device hopping the SIM. You may want to get a new SIM for your device.

Try doing as bjames said above first.

[Didneywhorl]

Maybe BillA can chime in, he is a PagePlus guy.