Wireless Joint

I think this topic raises a point worth mentioning. When someone is experiencing issues with a router and/or modem, it is best to start reading the various topics on this forum. If you can understand the problem and its cause, then finding a solution becomes a lot easier.

Most everything discussed ...

I too had similar issues with the WG3526 WiFi. It was suggested that the issues arrived from installing the WiFiX version of GoldenOrb and did not uncheck the box to save settings.

It is common to uncheck the box, then browse to the GoldenOrb firmware to upload, and when returning to the flash ...

Using the boot loader can be aggregating at times. I have used it on numerous occasions and after a while you sort of develop a touch for it. The important part seems to be the timing, deciding when to let off the reset button in order to access the boot loader menu.

I once timed the process and ...

One other thing is you might want to clear your browser cache prior to trying to access the bootloader menu.

You can normally do this by placing your mouse at the top of the open web page tab and pressing the Ctrl and F5 button at the same time.

One other change that I seem to have done on an ...

You have learned a lot and I commend your mindset to take no prisoners.

I notice the router is passing the APN "r.ispsn" to the modem so I assume you are using Sprint.

I seem to remember the Quectel modems need to be placed in LTE only to use with Sprint.

The WG3526 does have GB WAN/LAN ports.

You may want to look at the GoldenOrb tutorials for setting up load balancing and/or failover. https://www.ofmodemsandmen.com/features.html

I have several Arlo pro cameras that are located on the far end of the property which were almost out of range. This caused the cameras to disconnect and/or disrupt the video feed.

Since the Arlo Base Station operates over the 2.4GHz frequency, I decided to add some higher dbi external WiFi ...

I had considered buying a MOFI 5500 with the EM9191 since that modem doesn't appear to be supported by Rooter and from all the things I've read the EM9191 seems to be superior to the RM502Q.

The EM9191 is supported in the latest WIFIX firmware but does not yet have the option from the Web UI to ...

To repair the IMEI on the Quectel modems:
where x's represent the IMEI to be programmed into the modem.