After numerous attempts to reset a WE826-T2 (32M) - EC25-AF back to it's original GoldenOrb firmware for a fresh start, I gave up and had a brainiac idea to flash the firmware to solve the issue.
It took quite a few resets but was finally able to get it into recovery mode but whenever I try to flash the file the response is Checksum failed!
I've done a lot of searching on the forum and have tried different PC settings and so far it's still Checksum Failed!
Can some please help a rookie out?
WE826 Checksum Failed
Forum rules
Use the SEARCH function for related topics PRIOR to posting a new topic on the same subject.
Use the SEARCH function for related topics PRIOR to posting a new topic on the same subject.
-
Didneywhorl
- Posts: 3635
- Joined: Fri Mar 23, 2018 5:37 pm
- Location: USA
- Has thanked: 1369 times
- Been thanked: 761 times
- Contact:
-
Didneywhorl
- Posts: 3635
- Joined: Fri Mar 23, 2018 5:37 pm
- Location: USA
- Has thanked: 1369 times
- Been thanked: 761 times
- Contact:
Re: WE826 Checksum Failed
Honestly I've never seen a checksum check on the firmware recovery. Is this an old MOFI?
Re: WE826 Checksum Failed
It's a stock WE826-T2 that was up and running with GoldenOrb. Being a rookie I played with a lot of the settings trying to improve it's performance and for the learning experience. When I tried to reset it back to the original firmware nothing seemed to remove my tinkering so I finally decided to just flash a fresh image and that's where I'm now stuck with Checksum Failed.
You do not have the required permissions to view the files attached to this post.
Re: WE826 Checksum Failed
Yes, I flashed WE826 v2 with vanilla OpenWRT and ROOter without any problems. Always wanted to try WiFiX but it seems this firmware should not be installed on a non The Wireless Haven hardware due to legal reasons.
-
Didneywhorl
- Posts: 3635
- Joined: Fri Mar 23, 2018 5:37 pm
- Location: USA
- Has thanked: 1369 times
- Been thanked: 761 times
- Contact:
-
Rich Hathaway
- Posts: 609
- Joined: Mon Mar 08, 2021 2:41 pm
- Has thanked: 12 times
- Been thanked: 210 times
Re: WE826 Checksum Failed
@Ozark
you marked out the mac-id and the imei in your photo, but you left the barcodes, kind of defeats the purpose of marking them out don't you think.
you marked out the mac-id and the imei in your photo, but you left the barcodes, kind of defeats the purpose of marking them out don't you think.
-
JimHelms
- Site Admin
- Posts: 1362
- Joined: Tue Dec 19, 2017 8:59 pm
- Location: DFW Texas
- Has thanked: 79 times
- Been thanked: 194 times
- Contact:
Re: WE826 Checksum Failed
The initial issue is that you are trying to upload a .zip file.
You will need to extract it and upload the .bin file that is compressed within the .zip file.
You will need to extract it and upload the .bin file that is compressed within the .zip file.
