Looking For Tutoral On Setting Up My Quectel EM-12G Modem

[kzaudio]

Instead of searching high and low, is there a place where I can learn all the programming specs for this guy? Band Info, TTL, AT-Comands etc. Id love to learn this stuff but I returned my MoFi 4500 today and would like to get this bad boy setup quickly. Looking for Cliff's Notes for now if there are any. Using Visible.

Thanks guys

[gscheb]

Hello,

Here is a link on how to set up Visible on Quectel modems
https://wirelessjoint.com/viewtopic.php?f=32 ... lit#p11658

Also include a messy file of mine that I use as reference on the Quectel AT commands.

Quectel AT Commands.txt

[kzaudio]

@gscheb thanks man I'll give it a try

[megaplow]

@kzaudio @gsheb...
Were either of you able to get your EM-12Gs set up? I am moving from the EP06 to the EM-12. Currently I am able to connect but my speeds are slow. Can you share a set of at commands you used to get your devices running? I looked at the commands from the previous post, but those look more like notes than instructions.

It would be nice to know from a factory reset what is required.
Does it help to specify bands, or can I just have it autoscan?

Thanks!

[gscheb]

@kzaudio @gsheb...
Were either of you able to get your EM-12Gs set up? I am moving from the EP06 to the EM-12. Currently I am able to connect but my speeds are slow. Can you share a set of at commands you used to get your devices running? I looked at the commands from the previous post, but those look more like notes than instructions.
Thanks!

What service are you trying to get going?

[megaplow]

I am open to PagePlus (preferred) or SimpleMobile. I have all the router settings I need for those. What I am not sure about is what modem (at+commands) settings are needed to be addresses from a factory reset (for the Em-12g).

[gscheb]

https://wirelessjoint.com/viewtopic.php?f=15 ... tric#p9363

This post shows how to put modem in oem state.

[megaplow]

Thanks for that
I am looking for what commands are required after a fresh start (oem state).

In the txt doc provided above, the IPV Modes section looks carrier specific.
Do I run all the commands starting with ...Set Connection Modes?

[gscheb]

Just try the oem state command.

[gscheb]

After that try following this.

https://wirelessjoint.com/viewtopic.php?f=21&t=334

Most carriers this is all you need to do. Only some get more complicated.

[Ytgr848]

I ordered 1 QUECTEL EM12-G Modem.

I ordered 2 U-FL FEMALE to SMA Straight RG178 ANTENNA cables.

Here's my problem:. The Antenna cables DO NOT CONNECT to the Modem.

Are these the correct CABLES to CONNECT to the Modem?

If they are not, What are the correct
cables I should have?

Thank you for your prompt response!

[Didneywhorl]

Welcome!


You need MHF4 connectors on all M.2 style modems ("EM" modems, like EM12, EM20, EM7565, etc)

Like these: https://thewirelesshaven.com/shop/cables/pigtail- ... ail-cable/