Hello I am using a WG1608 running GO with the wireless of the 1608 turned off. I am using google wifi mesh system that I previous used with an M1 and my blink cameras will not do live playback and activity notifications are very delayed as well.
Provider is TMHI and previous setup was and M1 using magic wired to a switch which went out to the first mesh pod. Had no issue with this setup other than the M1 did not support the 5G is my area.
WG1608 is running a RM510Q-GL modem and over all works good, but is not playing nice with the google mesh system and other wireless device
I would basically like to use the 1608 as a modem only if possible and use a different inside the house to distribute DCHP if possible.
Anyone walk me through this?
WG1608 Issues with blink cameras
Forum rules
Use the SEARCH function for related topics PRIOR to posting a new topic on the same subject.
Use the SEARCH function for related topics PRIOR to posting a new topic on the same subject.
-
stryker6040
- Posts: 5
- Joined: Wed Mar 16, 2022 1:21 pm
- Has thanked: 0
- Been thanked: 0
-
Didneywhorl
- Posts: 3646
- Joined: Fri Mar 23, 2018 5:37 pm
- Location: USA
- Has thanked: 1370 times
- Been thanked: 764 times
- Contact:
-
stryker6040
- Posts: 5
- Joined: Wed Mar 16, 2022 1:21 pm
- Has thanked: 0
- Been thanked: 0
-
Didneywhorl
- Posts: 3646
- Joined: Fri Mar 23, 2018 5:37 pm
- Location: USA
- Has thanked: 1370 times
- Been thanked: 764 times
- Contact:
Re: WG1608 Issues with blink cameras
Simplest first thing is to use an IP (IPV4) only APN.
DBL check the APNs using AT+CGDCONT?
DBL check the APNs using AT+CGDCONT?
-
stryker6040
- Posts: 5
- Joined: Wed Mar 16, 2022 1:21 pm
- Has thanked: 0
- Been thanked: 0
