I was trying to flash different firmware and now I can not get in to recovery, I try assign ip address ex: 192.168.1.2, 255.255.255.0, 192.168.1.1, with or without dns 192.168.1.1, it does not take me to recovery mode anymore. I try holding the reset button for 15 to 30 sec no luck.
This is when I flash wrong firmware version that was openwrt mesh+
I think the recovery firmware got erase or something, I only see two light power, and l1 lan port,
I also tried with 3 different computer no luck.
I need to fix the recovery firmware please help
Wg1608 brick I flash wrong firmware
Forum rules
Please assure there is not an existing forum and topic related to your post
Please assure there is not an existing forum and topic related to your post
- Didneywhorl
- Posts: 3646
- Joined: Fri Mar 23, 2018 5:37 pm
- Location: USA
- Has thanked: 1370 times
- Been thanked: 764 times
- Contact:
Re: Wg1608 brick I flash wrong firmware
Mesh+ doesn't have recovery that I can figure out. They use a custom u-boot that seems to not have it.
You'll likely have to see if the serial ttl port is communicating and try to use that.
You'll likely have to see if the serial ttl port is communicating and try to use that.
- Didneywhorl
- Posts: 3646
- Joined: Fri Mar 23, 2018 5:37 pm
- Location: USA
- Has thanked: 1370 times
- Been thanked: 764 times
- Contact:
-
- Posts: 20
- Joined: Wed Feb 09, 2022 1:35 pm
- Has thanked: 4 times
- Been thanked: 8 times
Re: Wg1608 brick I flash wrong firmware
I assume you've already tried rescue as described here:
https://fccid.io/2AH9TW826/Users-Manual ... al-2994820 and here
https://openwrt.org/docs/guide-user/tro ... _partition
https://fccid.io/2AH9TW826/Users-Manual ... al-2994820 and here
https://openwrt.org/docs/guide-user/tro ... _partition