NEXP1GO with EM160R-GL

[kalistian]

Carrier:
AT&T & T-Mobile (load-balanced)
Distance_to_Tower:
3-4 miles
Type_of_Device:
WiFiX NEXP1GO (WG3526)
Type_of_Modem:
Quectel EM160R-GL
Firmware:
GoldenOrb_2021-11-16 (OpenWrt 19.07.6)
Antenna_Setup:
WiFiX 4×4 MIMO Antenna 700-3800MHz Cellular 8dBi Directional (± 45°) N Female Connectors
High Beam X2 – HIGH POWER 15dBi 2×2 MIMO Cellular 5G 4G LTE Directional Antenna 700-2700MHz (+45°/-45°) N Female Connectors
Cable_Type:
LMR200 Low Loss Duplex Coax (Dual) Cables N Male Connector 3 Feet – 2 x N Male – 2 x SMA Male Straight

[kalistian]

Extremely happy with this, took me quite a while to find towers here in Los Angeles that don't get congested down to unusable speeds. Have a T-Mobile tower 300 ft from my house, direct line of sight. INSANELY good signal, but entirely unusable cos it gets clogged so much. Shame that.

The ones I connect to are further out with barely any houses surrounding them. Helps a ton.

[Didneywhorl]

Fantastic speeds! Good stuff