Hello,
I just flashed a new wg1608 with the 3/31 goldenorb firmware. I finally got the modem (rm500q-ae) to show connected and its showing b14. I'm not getting any external ip address when I check the status page.
Also, the dhcp doesn't seem to be working. I'm having to manually set my ip address for my interface. I changed the ip address of the router to 192.168.8.1 but it is not giving me an ip address (my wifi get a 169.254 address)
any ideas?
issues with wg1608
Forum rules
Please assure there is not an existing forum and topic related to your post
Please assure there is not an existing forum and topic related to your post
-
Didneywhorl
- Posts: 3646
- Joined: Fri Mar 23, 2018 5:37 pm
- Location: USA
- Has thanked: 1370 times
- Been thanked: 764 times
- Contact:
Re: issues with wg1608
I would flash it fresh using the firmware recovery method. Then only do the minimum required to get connected to the internet and tested working. Zero other settings changes. Not even the password.
Just system time and modem connection profile default APN is my minimum settings. Thats it.
Once tested working, THEN change IP address of the gateway, wifi SSID, passwords, etc. And only change a few things at a time while saving and applying often.
Then
Just system time and modem connection profile default APN is my minimum settings. Thats it.
Once tested working, THEN change IP address of the gateway, wifi SSID, passwords, etc. And only change a few things at a time while saving and applying often.
Then
