NEXR5GO, EM7565, Visible Wireless NOT working

[hayedid]

Hi. I thought all this was up and running, but it only worked for a very short time and I have been out of town and haven't been able to follow up.

Router: NEXR5GO
Modem: EM7565

The best I can tell, I followed all the directions provided with the router. Since it isn't working, I have been trying various Firewall settings. Here is my status result:

AT!GSTATUS?
!GSTATUS:
Current Time: 729 Temperature: 36
Reset Counter: 2 Mode: ONLINE
System mode: LTE PS state: Attached
LTE band: B66 LTE bw: 15 MHz
LTE Rx chan: 0 LTE Tx chan: [6 digit number was here]
LTE SSC1 state:NOT ASSIGNED
LTE SSC2 state:NOT ASSIGNED
LTE SSC3 state:NOT ASSIGNED
LTE SSC4 state:NOT ASSIGNED
EMM state: Registered Normal Service
RRC state: RRC Idle
IMS reg state: No Srv

PCC RxM RSSI: -64 PCC RxM RSRP: -96
PCC RxD RSSI: -70 PCC RxD RSRP: -106
Tx Power: -- TAC: 1903 (6403)
RSRQ (dB): -12.5 Cell ID: [7 digit number was here]
SINR (dB): 0.4

Any ideas what might be wrong?

Thank you.

[hayedid]

Hmmm... found a thread about making the modem 'GENERIC' rather than visible. Re-ran that. Switched back to port 64 and seem to be up and running again.

[Didneywhorl]

Getting behind on all the posts. Yeah, Generic is the way with Sierra cards, unless you have a SIM and plan that is actually registered with the Sierra directly. Then the carrier firmware is best.