MoFi4500 Sim 7 and Passthrough

[topbilling]

Hey -- did some searching on the boards and haven't found anything on this topic. I'm having trouble setting up pass through on the Sim7. I have a Sim3 also and passthrough works just fine with my router which is handling DHCP. Weirdly, when I setup the Sim7, I'm able to connect to the internet on a device which is hardwired to the DHCP router, but not on any wireless devices which are connected through a Netgear AP wired to the DHCP router.

To be clear, my intended set up is MoFi4500 Sim7 ---> CradlePoint Router (AER1600) ---> Netgear Orbi AP. This works with the Sim3 version, but not the Sim7. Any tips would be greatly appreciated!

[Dr-BroadBand]

MoFi - Enabling IP-Passthrough(Bridge) Mode

See

https://support.unlimitedville.com/supp ... ridge-mode

[topbilling]

Followed the instructions to a T. Works just fine with the Sim3. Wonder if it's related to the modem...

[Dr-BroadBand]

What version of firmware are you using? …. On MoFi Sim-7??

[topbilling]

FIRMWARE 1_1_0std
http://mofinetwork.com/firmware/mofi4500v3/mofi4500_4GXeLTE_V3Firmware1_1_0std.bin

[Dr-BroadBand]

Firmware looks good.

I have seen magic happen with a hard factory reset of the MoFi.

Make a back up of your settings and do screen shots.
Remove the SIM and do a factory reset of the MoFi.

[topbilling]

Much appreciated!

[topbilling]

Tried hard reset and no go. I'm not super familiar with the Mofi4500 interface. Where would I look in the GUI to compare the settings/status of the Sim3 unit which is working fine with IP passthrough to the Sim7 which I just can't seem to get working?

[Dr-BroadBand]

Is the MoFi set for passthrough?

And you are connected to Lan Port #1