EM9191 holding a 5g connection?
Posted: Wed Oct 26, 2022 5:39 pm
I have a NEXS2GO, EM9191, and the 5g paddle antennas all from wireless haven. I've been running this setup for a few months off a tmobile sim.
So far it has worked decently but one thing that is frustrating me is how spotty the 5g connection is. It typically stays with the 4g bands. It's very rare that I ever see it in NSA mode.
I'm wondering if I'm doing something wrong because my cell phone basically gets full bars 5g on n41. The tmobile map even shows that my location gets n41/71.
If it helps at all my apn is fast.t-mobile.com with a ttl of 64. (ttl didn't seem to change speed all that much.)
My gstatus is a bit unusual atm because it seems to only want to use band 2 today. Speed hasnt been different though.
cnum and cpin? return the correct respond. The only thing I've actually done to this is magic it. Also ordered the firmware update from wireless haven when I got it.
Is there just something up with the EM9191, or am I missing some configuration? I find it really hard to believe I can't get a strong 5g signal off 4 paddle antennas when my phone is going full blaze.
So far it has worked decently but one thing that is frustrating me is how spotty the 5g connection is. It typically stays with the 4g bands. It's very rare that I ever see it in NSA mode.
I'm wondering if I'm doing something wrong because my cell phone basically gets full bars 5g on n41. The tmobile map even shows that my location gets n41/71.
If it helps at all my apn is fast.t-mobile.com with a ttl of 64. (ttl didn't seem to change speed all that much.)
Code: Select all
AT!GSTATUS?
!GSTATUS:
Current Time: 2578 Temperature: 43
Modem Mitigate Level: 0 ModemProc Mitigate Level: 0
Reset Counter: 1 Mode: ONLINE
System mode: LTE PS state: Attached
LTE band: B2 LTE bw: 20 MHz
LTE Rx chan: 4294967295 LTE Tx chan: 4294967295
LTE SSC1 state:INACTIVE LTE SSC1 band: B4
LTE SSC1 bw : 20 MHz LTE SSC1 chan: 2300
LTE SSC2 state:INACTIVE LTE SSC2 band: B71
LTE SSC2 bw : 5 MHz LTE SSC2 chan: 0
EMM state: Registered Normal Service
RRC state: RRC Connected
IMS reg state: UNKNOWN IMS mode: Not Support
IMS Srv State: UNKNOWN SMS,UNKNOWN VoIP
PCC RxM RSSI: -70 PCC RxM RSRP: -106
PCC RxD RSSI: -69 PCC RxD RSRP: -106
PCC RxM1 RSSI: -64 PCC RxM1 RSRP: -107
PCC RxD1 RSSI: -62 PCC RxD1 RSRP: -107
SCC1 RxM RSSI: -83 SCC1 RxM RSRP: -110
SCC1 RxD RSSI: -90 SCC1 RxD RSRP: -118
SCC1 RxM1 RSSI: --- SCC1 RxM1 RSRP: ---
SCC1 RxD1 RSSI: --- SCC1 RxD1 RSRP: ---
SCC2 RxM RSSI: -74 SCC2 RxM RSRP: -103
SCC2 RxD RSSI: -74 SCC2 RxD RSRP: -105
Tx Power: 21 TAC: ffff (65535)
RSRQ (dB): -14.9 Cell ID: ffffffff (4294967295)
SINR (dB): 4.8
NR5G band: --- NR5G bw: ---
NR5G Rx chan: --- NR5G Tx chan: ---
NR5G RSRP (dBm): --- NR5G RSRQ (dB): ---
NR5G SINR (dB): ---
OKcnum and cpin? return the correct respond. The only thing I've actually done to this is magic it. Also ordered the firmware update from wireless haven when I got it.
Is there just something up with the EM9191, or am I missing some configuration? I find it really hard to believe I can't get a strong 5g signal off 4 paddle antennas when my phone is going full blaze.