What is RSSI vs RSRP? - Just want a yes/no confirm

[Dre40]

Is this correct (I'm fiddling with my antennas again, just moved spots). Just want to confirm:

Rxm RSSI is the LTE signal strength (primary input)
RxD RSSI is the LTE signal strength (secondary input)
RSRQ (dB): is the signal quality

So I can ignore RxM RSRP db as these are the indoor antennas (i'm using a 2nd bypassed wifi router for indoor wifi.

This is getting me 15-22mb down with the aggregation (tower is about 5 miles away)

at!gstatus?
!GSTATUS:
Current Time: 307 Temperature: 56
Reset Counter: 4 Mode: ONLINE
System mode: LTE PS state: Attached
LTE band: B66 LTE bw: 20 MHz
LTE Rx chan: 0 LTE Tx chan: 132322
LTE SCC1 state:ACTIVE LTE SCC1 band: B12
LTE SCC1 bw : 5 MHz LTE SCC1 chan: 5035
LTE SCC2 state:NOT ASSIGNED
LTE SCC3 state:NOT ASSIGNED
LTE SCC4 state:NOT ASSIGNED
EMM state: Registered Normal Service
RRC state: RRC Connected
IMS reg state: No Srv

PCC RxM RSSI: -63 PCC RxM RSRP: -105
PCC RxD RSSI: -68 PCC RxD RSRP: -110
SCC1 RxM RSSI: -60 SCC1 RxM RSRP: -91
SCC1 RxD RSSI: -66 SCC1 RxD RSRP: -97
Tx Power: 19 TAC: 2c28 (11304)
RSRQ (dB): -16.6
SINR (dB): -2.6

[gscheb]

Rxm RSSI is the LTE signal strength (primary input)
RxD RSSI is the LTE signal strength (secondary input)
RSRQ (dB): is the signal quality

Yes and yes and yes

Screenshot_20200423-013113.png

[Dre40]

Thank you. Very helpful. got a little better RSRQ by moving it around (Grid type).

System mode: LTE PS state: Attached
LTE band: B41 LTE bw: 20 MHz
PCC RxM RSSI: -73 PCC RxM RSRP: -102
RSRQ (dB): -9.1
SINR (dB): 9.2

Now if I can just figure out why the modem keeps disconnecting every few seconds.