Yes there is, if you go to Modem --> Network Status --> and look under Signal Status, you should see the Network Icon that tells you if you are on LTE or less. For Carrier Aggregation, go further down the page to Cell Information and look at Band status. Here it will display what band your modem is using plus any additional bands that are being utilized for Carrier Aggregation. Carrier Aggregation is not a full time process, I have only see CA being utilized under heavy load for my devices.Prvt.N00b wrote: Fri Jan 08, 2021 1:07 pm is there a way to know when my modem is connected to an LTE+ tower or using LTE+, or do I have to assume that if the modem is showing carrier aggregation then is using LTE+.
Code: Select all
AT!GSTATUS?Code: Select all
AT!GSTATUS?
!GSTATUS:
Current Time: 116883 Temperature: 26
Reset Counter: 1 Mode: ONLINE
System mode: LTE PS state: Attached
LTE band: B66 LTE bw: 10 MHz
LTE Rx chan: 0 LTE Tx chan: 132622
LTE SSC1 state:INACTIVE LTE SSC1 band: B1
LTE SSC1 bw : 20 MHz LTE SSC1 chan: 850
LTE SSC2 state:INACTIVE LTE SSC2 band: No band
LTE SSC2 bw : 5 MHz LTE SSC2 chan: 0
LTE SSC3 state:NOT ASSIGNED
LTE SSC4 state:NOT ASSIGNED
EMM state: Registered Normal Service
RRC state: RRC Connected
IMS reg state: No Srv
PCC RxM RSSI: -46 PCC RxM RSRP: -76
PCC RxD RSSI: -58 PCC RxD RSRP: -87
SCC1 RxM RSSI: -56 SCC1 RxM RSRP: -76
SCC1 RxD RSSI: -63 SCC1 RxD RSRP: -83
SCC2 RxM RSSI: -59 SCC2 RxM RSRP: -76
SCC2 RxD RSSI: -74 SCC2 RxD RSRP: -91
Tx Power: -1 TAC: 228e (8846)
RSRQ (dB): -12.0 Cell ID:
SINR (dB): 26.6
OK