Hello All
Really like the information found here. I am new to openwrt/GO and such. Not new to tech or linux. I just wanted to say hello and hope to have some good questions as I learn here.
In general my interest is having a mobile cellular gateway. I want it to use normal ethernet wan, wifi "piggyback" wan, and cel wan. I assume if ethernet is available use that > Cel then > wifi connection.
I recently got a ZBT 1326 and a PCIe ep06-a. Something to learn on. Thanks again
Hello All
-
BillA
- Posts: 1230
- Joined: Sun Dec 01, 2019 6:46 pm
- Location: USA
- Has thanked: 219 times
- Been thanked: 327 times
- Contact:
Re: Hello All
Factor wrote: Wed Jan 29, 2020 1:40 pm Hello All
Really like the information found here. I am new to openwrt/GO and such. Not new to tech or linux. I just wanted to say hello and hope to have some good questions as I learn here.
In general my interest is having a mobile cellular gateway. I want it to use normal ethernet wan, wifi "piggyback" wan, and cel wan. I assume if ethernet is available use that > Cel then > wifi connection.
I recently got a ZBT 1326 and a PCIe ep06-a. Something to learn on. Thanks again
Were you able to get your "Cell> WiFi connection" working?
-
Factor
- Posts: 32
- Joined: Wed Jan 29, 2020 11:55 am
- Location: Tennessee
- Has thanked: 1 time
- Been thanked: 5 times
Re: Hello All
Bill
I am going to try the ZBT 1326 tomorrow. I was able to get the modem to present on the PC engines API3c4. I couldn't get the kmods and wifi drivers to install for my wle900 wifi module the version or kernel was too old in the GO v18 firmware.
