Need assistance regaining access to KuWfi (cpe812cat6) AP

[karlito]

Hello all,

I have this multi-mode KuWfi router. It can work as a 4G router with a SIM, normal router connected to WAN and having it's LAN, as a wireless repeater and also as a wireless AP.

I am currently using it as a wireless AP the following way:
KuWfi AP is connected to a switch which is connected to my main router which is connected to the WAN.
The KuWfi is on it's own vlan and DHCP happens on the main router.

I did some testing and am happy with my setup, however while testing I had setup a weak password for both my wifi and admin console on the KuWfi. Now I'd like to change those to stronger passwords, however I seem to have lost access to the KuWfi console.

I connect to the KuWfi AP via wifi from my laptop and have internet connectivity and am being assigned an IP from the appropriate vlan. However I can't seem to find the address for the KuWfi device, I tried used nmap to scan the /24 range of my lan while connected to the KuWfi AP, however I find only the main router IP, the switch management console IP and the IP assigned to my laptop.

Do you guys know how I can regain access to the KuWfi console to tighten security?
Would I have to reset the device and set it up again but with stronger seurity or is there some way of getting into it?

Thanks!

[DDK65JAG]

Should be pretty easy, if you're happy with the network set-up "as-is".
Just disconnect the KuWfi from your network, plug an ethernet cable
from your computer directly to a LAN port on the KuWfi, log into the GUI
and make your changes. Then re-install the KuWfi back into the network.

Good luck, DDK

P.S. You may have to turn off your wi-fi on the computer while trying to connect to the KuWfi.