Have a mofi 4500 and The Wireless Haven WG3526 load balanced by a TL-R600VPN (cat5 from that to PCs) and then a Wifi5 TP Link 1900AC router for good strong wifi (covers every spot in the home, antennas in LTE routers turned off). Speeds range from 5-20mb (I am a long way from towers/lots of trees this is best I can get, peaks sometimes near 40 though)
I can't figure out how to put the WG into bridge mode
How put WG3526 in bridge / pass through mode
Forum rules
Please assure there is not an existing forum and topic related to your post
Please assure there is not an existing forum and topic related to your post
Re: How put WG3526 in bridge mode
Edit: Found in search: https://wirelessjoint.com/viewtopic.php?f=9& ... dge#p16979
Sounds like it is not possible with the openWRT software on WG3526? That still the case? Should I switch to something else (software wise)?
Edit 2: Will try this: https://wirelessjoint.com/viewtopic.php?f=8& ... 0c1#p15084
Sounds like it is not possible with the openWRT software on WG3526? That still the case? Should I switch to something else (software wise)?
Edit 2: Will try this: https://wirelessjoint.com/viewtopic.php?f=8& ... 0c1#p15084
