Search found 7 matches
- Wed Jul 10, 2019 4:55 pm
- Jump to forum
- Jump to topic
Re: WE1326 question
Good question! I haven't looked at mine close enough to tell and it did seem like more should have been in use. Interested in hearing what others have to say. It might be a limitation of router firmware too.
- Thu Jul 18, 2019 7:19 am
- Jump to forum
- Jump to topic
Re: EM7455 set to qmi?
Nice detective work, and thanks for sharing!jose.herrera wrote: ↑Thu Jul 18, 2019 6:15 am I found a solution if anyone ever gets stuck in my position. I ran these commands.
And it defaulted to MBIM,but running the commands for qmi again were successful after the reset.
- Fri Jul 19, 2019 3:07 pm
- Jump to forum
- Jump to topic
- Sat Jul 20, 2019 6:02 am
- Jump to forum
- Jump to topic
Re: EM7455 set to qmi?
I realized that difference after I posted about it.jose.herrera wrote: ↑Fri Jul 19, 2019 10:17 pm I used the command for EM/MC7455 which is at!usbcomp=1,1,10d and had the exact issue you did, but my modem is a EM7455 Not a EM7565.
So you were able to fix it?
- Wed Jul 24, 2019 6:54 am
- Jump to forum
- Jump to topic
Re: EM7455 set to qmi?
I wonder if the previous modem was damaged/corrupted in some way? Well it's been sent back. I wonder if this has to do something with the new firmware which is on revision 26,as when I was using the other revision 23 or 24 was the most recent. It is possible that the VID/PID numbers were modified ...
- Thu Jul 25, 2019 5:54 pm
- Jump to forum
- Jump to topic
Sprint and EM7455 - solution to disconnects?
I purchased a Sprint unlimited sim/hotspot through one of the Mobile Citizen vendors. Hoping to be able to use it in my em7455, however after experimenting for a while I seem to suffer from the frequent disconnects/instability that so many others have. I've read many threads on the issue and they ...
- Sat Jan 26, 2019 2:49 pm
- Jump to forum
- Jump to topic
WG3526 EM7565 Modem Present Not Connected
Please help. Having trouble getting my new WG3526 router to recognize the EM7565 modem. I get the disappearing text when I try to type anything in the AT Command box. Any advice would be greatly appreciated. I am very new to all of this. Device Information T: Bus=01 Lev=00 Prnt=00 Port=00 Cnt=00 Dev ...