Wireless Joint

Posted: **Wed Jan 29, 2020 1:40 pm**

Hello All
Really like the information found here. I am new to openwrt/GO and such. Not new to tech or linux. I just wanted to say hello and hope to have some good questions as I learn here.

In general my interest is having a mobile cellular gateway. I want it to use normal ethernet wan, wifi "piggyback" wan, and cel wan. I assume if ethernet is available use that > Cel then > wifi connection.

I recently got a ZBT 1326 and a PCIe ep06-a. Something to learn on. Thanks again

Posted: **Mon Feb 17, 2020 9:14 pm**

Factor wrote: Wed Jan 29, 2020 1:40 pm Hello All
Really like the information found here. I am new to openwrt/GO and such. Not new to tech or linux. I just wanted to say hello and hope to have some good questions as I learn here.

In general my interest is having a mobile cellular gateway. I want it to use normal ethernet wan, wifi "piggyback" wan, and cel wan. I assume if ethernet is available use that > Cel then > wifi connection.

I recently got a ZBT 1326 and a PCIe ep06-a. Something to learn on. Thanks again

Were you able to get your "Cell> WiFi connection" working?

Posted: **Tue Feb 18, 2020 8:27 pm**

BillA wrote: Mon Feb 17, 2020 9:14 pm Were you able to get your "Cell> WiFi connection" working?

Bill
I am going to try the ZBT 1326 tomorrow. I was able to get the modem to present on the PC engines API3c4. I couldn't get the kmods and wifi drivers to install for my wle900 wifi module the version or kernel was too old in the GO v18 firmware.

Wireless Joint

Hello All

Hello All

Re: Hello All

Re: Hello All