Wireless Joint

Hello all. Does anybody have a link to ZBT Factory firmwares? Maybe an FTP site?

which model?

WE1326-BKC in particular. I was hoping I could get these directly from ZBT though if anybody has a link. In the router there is a firmware update detector, I just can't figure out how to decode what website it pulls updates from.

I also just need a "base" firmware I can use to reflash back to factory just in case the need arises.

Ill ask about, I just have the we826 firmware, no links.

tambutso wrote: Fri Jan 17, 2020 9:21 pm Hello all. Does anybody have a link to ZBT Factory firmwares? Maybe an FTP site?

You could try emailing ZBT directly at info@zbt-china.com and ask for the factory firmware.
Keep in mind, that Chinese New Year runs from Jan 25th through Feb 8th in 2020, so they may not reply till it's over. They usually start celebrations a week before Jan 25th.

Here are some more resources (commence at your own risk!)

https://starthotspot.com/help/zbt.html
https://go.starthotspot.com/help/zbt/

zbt-we1326-initramfs-kernel.bin
https://downloads.openwrt.org/releases/ ... kernel.bin

zbt-we1326-squashfs-sysupgrade.bin
https://downloads.openwrt.org/releases/ ... pgrade.bin

The following info is from a Russian forum (https://4pda.ru/forum/index.php?showtopic=837347&st=820)

The binary file flash.bin (16384 KiB) consists of u-boot (192 KiB), u-boot-env (64 KiB), factory(64 KiB) and firmware (16064 KiB).

If you have a working u-boot or OpenWrt/LEDE, you only need the firmware partition.
It can be extracted by
tail -c 16064 KiB flash.bin > firmware.bin

The following *should* work:
1. Use LuCI (do not keep settings).
2. Upload it to /tmp/firmware.bin then
sysupgrade -n /tmp/firmware.bin
3. Upload it to /tmp/firmware.bin then
mtd write /tmp/firmware.bin firmware
4. Use the u-boot, by web or UART&sftp.

If you want to keep your MAC address, backup/recover the factory partition.

On a related note. Is it possible to backup a router's current firmware directly from the device? For backup purposes, just in case I need to go back to factory firmware someday.

tambutso wrote: Tue Jan 21, 2020 10:52 pm On a related note. Is it possible to backup a router's current firmware directly from the device? For backup purposes, just in case I need to go back to factory firmware someday.

You could probably use the Linux "dd" command just like on Androids, by logging into root through Telnet or PUTTY (192.168.1.1). For example at the root prompt # enter:

dd if=/dev/block/<sda0-20> of=/sdcard/<sda0-20> <bs=x count=x>

Since I'm not too familiar with the OpenWRT partition layout, you would have to research the exact "if=" input block numbers and the "of=" output file destination, along with the "bs=" buffer size and "count=" block count.

Hello. And for wg1608 you can find factory firmware. 32mb. Thank you.