Wireless Joint

Greetings,
I'm currently trying to set up and configure a new connection using a MC7455 modem. I've run the following commands to get it configured:
at!entercnd="A710"
at!usbcomp=1,1,1009
At!reset

Then manually reboot the router.
Log back into it and run these commands:

at!entercnd="A710"
at!band=0d,"Sprint (All)",0,10003000000
at!band=0a,"B41",0,10000000000
at!band=0b,"B25",0,00001000000
at!band=0c,"B26",0,00002000000
at!band=0a
At!reset

When I perform a at!gstatus? command, it says I"m connected to Channel 13, and has a verizon configuration on it. I've tried to flash it back to basic generic firmware, but it continues to display the incorrect information.

Any thoughts or suggestions to remediate this bizarre situation?

Regards

Clear the band locks and what dose it connect to?

frizzanz wrote: ↑Thu Jan 16, 2020 11:22 am When I perform a at!gstatus? command, it says I"m connected to Channel 13, and has a verizon configuration on it. I've tried to flash it back to basic generic firmware, but it continues to display the incorrect information.

Any thoughts or suggestions to remediate this bizarre situation?

Regards

You might refer to THIS topic.