M01K21 router with GoldenOrb - Unable to use newer builds
Posted: Mon Jul 29, 2024 8:58 am
I have a Suncomm S2 router that I use with an AT&T plan (Mobley). I upgraded it from the stock Suncomm firmware to GoldenOrb firmware in April of this year using the 3-27-2024 build found at http://aturnofthenut.com/autobuild and the router has been working great.
I normally don't upgrade the router firmware too often, but decided to install the most recent version on the autobuild site. I installed the 7-11-2024 build but after installing it, I could no longer connect to the internet. I checked all the settings and everything looked like it did before although there were more settings in the TTL section. The modem log shows it was connecting to the AT&T network as expected. I then tried the 7-04-2024 build and experienced the same issue of no internet connectivity.
I decided to revert to the build I had been using and again installed the 3-27-2024 build. I was able to again connect to the internet as before.
I'll continue to use the 3-27-2024 build for now but was curious if anyone has had success with the newer autobuilds on the M01K21 router.
I normally don't upgrade the router firmware too often, but decided to install the most recent version on the autobuild site. I installed the 7-11-2024 build but after installing it, I could no longer connect to the internet. I checked all the settings and everything looked like it did before although there were more settings in the TTL section. The modem log shows it was connecting to the AT&T network as expected. I then tried the 7-04-2024 build and experienced the same issue of no internet connectivity.
I decided to revert to the build I had been using and again installed the 3-27-2024 build. I was able to again connect to the internet as before.
I'll continue to use the 3-27-2024 build for now but was curious if anyone has had success with the newer autobuilds on the M01K21 router.