Page 1 of 1
Netgear Mr6500 fail to broastcast wifi evenif broastcast ssid enabled already.
Posted: Thu Feb 15, 2024 8:31 pm
by ZzzzShinzzzZ
Has anyone encountered this issue on their Nighthawk hotspot before? It’s an unlocked MR6500, works fine via Ethernet and USB tethering, but will not broadcast WiFi it has
beside the WiFi symbol. Is there a command I can run to try to fix it? I’ve done a hard reset already and no luck.
Re: Netgear Mr6500 fail to broastcast wifi evenif broastcast ssid enabled already.
Posted: Wed Mar 13, 2024 8:06 pm
by BillA
ZzzzShinzzzZ wrote: Thu Feb 15, 2024 8:31 pm
Has anyone encountered this issue on their Nighthawk hotspot before? It’s an unlocked MR6500, works fine via Ethernet and USB tethering, but will not broadcast WiFi it has
beside the WiFi symbol. Is there a command I can run to try to fix it? I’ve done a hard reset already and no luck.
Try a factory reset using the hardware method.
https://kb.netgear.com/9665/How-do-I-pe ... EAR-router
Set up it again and see if WiFi is broadcasting, if not then probably the WiFi chip is fried.
beside the WiFi symbol. Is there a command I can run to try to fix it? I’ve done a hard reset already and no luck.