Page 1 of 1

NEXP1GO with EM160R-GL

Posted: Sun Dec 26, 2021 11:35 am
by kalistian
Carrier:
AT&T & T-Mobile (load-balanced)
Distance_to_Tower:
3-4 miles
Type_of_Device:
WiFiX NEXP1GO (WG3526)
Type_of_Modem:
Quectel EM160R-GL
Firmware:
GoldenOrb_2021-11-16 (OpenWrt 19.07.6)
Antenna_Setup:
WiFiX 4×4 MIMO Antenna 700-3800MHz Cellular 8dBi Directional (± 45°) N Female Connectors
High Beam X2 – HIGH POWER 15dBi 2×2 MIMO Cellular 5G 4G LTE Directional Antenna 700-2700MHz (+45°/-45°) N Female Connectors
Cable_Type:
LMR200 Low Loss Duplex Coax (Dual) Cables N Male Connector 3 Feet – 2 x N Male – 2 x SMA Male Straight

Image
Image

Re: NEXP1GO with EM160R-GL

Posted: Sun Dec 26, 2021 11:37 am
by kalistian
Extremely happy with this, took me quite a while to find towers here in Los Angeles that don't get congested down to unusable speeds. Have a T-Mobile tower 300 ft from my house, direct line of sight. INSANELY good signal, but entirely unusable cos it gets clogged so much. Shame that.

The ones I connect to are further out with barely any houses surrounding them. Helps a ton.

Re: NEXP1GO with EM160R-GL

Posted: Mon Dec 27, 2021 5:19 pm
by Didneywhorl
Fantastic speeds! Good stuff