WG3526 - EM160 4x4 Mimo update settings
Posted: Mon Oct 04, 2021 5:25 pm
Good Afternoon!
First I want to thank everyone for your posts and assistance. They have helped so much on my build.
With that said, I do have an issue that i am hoping someone can help.
I have a WG3526 from The Wireless Haven with a EM160 PoE in a The Wireless Haven 4x4 Mimo enclosure. This setup, runs inside to an Archer A7 router for wifi inside the house. I really like this set up and has worked great up until a few months ago. The WG3526 started dropping the signal, mainly under load from what I can tell? I would reboot it and it would be fine for awhile. Then do it again. Maybe a couple of days. I had the 2.20.21 Firmware. I did read that there were a few having this issue as well.
My issue: I tried to update the Firmware to the Global 9/11 update. All worked well, I flashed it 3 times, etc. Everything seemed to be ok. However, my connection from the WG3526 to my router does not have a signal. I unplugged it and plugged it directly into my computer. It doesn't like the network it seems? I think it is a network setting somewhere? I can't seem to find the answer anywhere? I can connect over the wifi no problems, however I can't get a signal through my Ethernet cable. I have tried other cables too. It seems to work fine. I even reverted it back to the 2/20 calibration, and set up the PoE and it works like it did. I am sure it is a setting or something not set up? Any help or direction would be greatly appreciated! Thanks Have a great day!
First I want to thank everyone for your posts and assistance. They have helped so much on my build.
With that said, I do have an issue that i am hoping someone can help.
I have a WG3526 from The Wireless Haven with a EM160 PoE in a The Wireless Haven 4x4 Mimo enclosure. This setup, runs inside to an Archer A7 router for wifi inside the house. I really like this set up and has worked great up until a few months ago. The WG3526 started dropping the signal, mainly under load from what I can tell? I would reboot it and it would be fine for awhile. Then do it again. Maybe a couple of days. I had the 2.20.21 Firmware. I did read that there were a few having this issue as well.
My issue: I tried to update the Firmware to the Global 9/11 update. All worked well, I flashed it 3 times, etc. Everything seemed to be ok. However, my connection from the WG3526 to my router does not have a signal. I unplugged it and plugged it directly into my computer. It doesn't like the network it seems? I think it is a network setting somewhere? I can't seem to find the answer anywhere? I can connect over the wifi no problems, however I can't get a signal through my Ethernet cable. I have tried other cables too. It seems to work fine. I even reverted it back to the 2/20 calibration, and set up the PoE and it works like it did. I am sure it is a setting or something not set up? Any help or direction would be greatly appreciated! Thanks Have a great day!