Page 1 of 1

WG3526 and GoldenOrb Settings

Posted: Sun Sep 19, 2021 10:40 am
by LTE_boi
I have two WG3526s and one Visible SIM. I have noted this puzzling behavior on both devices.

When using the stock Chinese firmware, I cannot hold a steady connection longer than 3-4 minutes before it drops. When it is working, I can access any website from any device without issue.

After flashing to GoldenOrb, specifically WiFiX-NEXP1GO-GO2021-09-11a I can hold a steady connection indefinitely. However, certain websites simply will not load when I attempt to access them over WiFi from either my personal or work-issued Android phone. Eventually I get an ERR_CONNECTION_CLOSED message in Chrome.

On a PC, this issue does not exist. When running an AT&T SIM in both units or either the stock Chinese or GoldenOrb firmware, this issue does not exist.

Any ideas on how to correct this issue?

Re: WG3526 and GoldenOrb Settings

Posted: Mon Sep 20, 2021 4:34 pm
by Didneywhorl
Did you flash the firmware to the routers like 3x in a row and uncheck the "save settings" box?

Sometimes the oddest junk stays in there when you update firmware, especially if you try and save your old settings.

Re: WG3526 and GoldenOrb Settings

Posted: Mon Sep 20, 2021 6:37 pm
by Adm1jtg
I would go back to a full factory reset... where you get the chinese load screen and try to load the firmware clean. If you get the same results I would go back a version and see if the problem still exists.

There is a previous version posted in the same area from feb 2021

There is also a version from rooter from aug 2021 you could also try

In each case I would say do a compete factory format before loading and do not restore any backups.