Wireless Joint

Hello All,

I have a WE826-T2 w/ an MC7455 running GoldenOrb GoldenOrb_2020-03-01 (OpenWrt 18.06.7) that I have connected to a pfSense box running failover.

I am able to bring the WE826-T2 online and get Internet, but when I trigger failover on the pfSense box and start routing over the WE826, the MBIM connection drops within 10 seconds. The only error log I can find in OpenWRT is "user.notice MBIM Monitor: Modem 1 Connection is Down (activation state: deactivated)"

Running AT!GSTATUS? shows that RRC State is "RRC Idle" which I believe means that the modem has dropped its connection to the LTE network.

I have tried extensive troubleshooting including QMI and MBIM connections, setting up Policy based routing on the pfSense box and directing certain machines out the LTE connection (this works fine). It only crashes out when all traffic is pushed out through the LTE connection. I'm wondering if the sheer amount of devices on the network trying to get out simultaneously causes the modem to freak out...

I'm pretty sure this is not hardware as we had a WE3526 with another MC7455 connection which experienced the same issue. Could a signal problem cause this issue?

Any advice would be appreciated. I am troubleshooting this remotely, but have a reliable primary connection, so I can bang on it without breaking my remote connection.

AT!GSTATUS?
!GSTATUS:
Current Time: 33809 Temperature: 39
Reset Counter: 9 Mode: ONLINE
System mode: LTE PS state: Attached
LTE band: B13 LTE bw: 10 MHz
LTE Rx chan: 5230 LTE Tx chan: 23230
LTE CA state: NOT ASSIGNED
EMM state: Registered Normal Service
RRC state: RRC Idle
IMS reg state: No Srv IMS mode: Normal
PCC RxM RSSI: -74 RSRP (dBm): -100
PCC RxD RSSI: -77 RSRP (dBm): -103
Tx Power: -- TAC: 4203 (16899)
RSRQ (dB): -8.2 Cell ID: 01021902 (16914690)
SINR (dB): 12.0
OK
AT!PCTEMP?
Temp state: Normal
Temperature: 40.00 C
OK

Are you using ipv6 locally? You may want to disable ipv6 on the modem, or on that VLAN?

I have IPv6 disabled on the LAN interface, I don't have it disabled on the WAN. I will try that.

Didneywhorl wrote: Tue Nov 03, 2020 12:38 pm Are you using ipv6 locally? You may want to disable ipv6 on the modem, or on that VLAN?

Can someone show me what this is talking about? Not sure I know about this. Could this effect ping if I am trying to deactivate ipv6 on the modem only?
Thanks

Did you ever figure this out? Using a Mikrotik LTE6 and experiencing the exact same behavior, once the amount of outgoing connections reaches 1000 it will drop and reset the LTE connection.