EM20 Questions on Antenna connections.
Posted: Wed Jun 24, 2020 11:57 pm
On the EM20 there are 4 Connections
M M1 M2 and D/G
if only running two antenna's which should I use?
Is there any benefit of running 3 ? or does it have to be 2 or 4?
Is there a command to see the signal strength of each antenna?
My old Sierra modem had a nice status comannd that showed that info.
these commands I found do not work for me
I found a list of commands here someplace and copied them to a notepad, but can't find the link here again.
any help would be great.
thanks
Ziggy
M M1 M2 and D/G
if only running two antenna's which should I use?
Is there any benefit of running 3 ? or does it have to be 2 or 4?
Is there a command to see the signal strength of each antenna?
My old Sierra modem had a nice status comannd that showed that info.
these commands I found do not work for me
they all error out.Modem Status
AT+qnetdevstatus
AT+QNETDEVSTATUS
AT+QCAINFO < CA Info
I found a list of commands here someplace and copied them to a notepad, but can't find the link here again.
any help would be great.
thanks
Ziggy