Anyone with m5100 kind enough to help

[LadyAskme]

Hello everyone, I'm pretty new to this site & would like to thank the admin/group for accepting me
so I have "M5100 which I would like to band lock to N60/N66 5G bands only I tried using dc unlocker
the programs gives error message when writing N60 also N66 doesn't work when selected thru the night hawk app
I was wondering if anyone can give me the code to manually write these two bands
I'm using putty to connect to port 5510 any help would be great
and currently using At&t unlimited iPad 5G plan

[Rich Hathaway]

That AT&T device can see N66 but I don think it can see any N60 band is prob why the error, are you in the USA.
are you sure you have N66 available in your location?
If you are sure,
You may also need to go into the admin page to settings then to advanced then network (the page where the apn is)
and set it to 5G only.

[LadyAskme]

Hey, Rich Hathaway how are you ? yes I'm located in the "USA" whenever I click on read bands in dc unlocker it shows the available bands
I attached screenshot so you can see, I'm willing to use putty to manually change the bands but I just need some guidance on how to properly
apply it was wondering if someone could give me the At! commands for band N66 & N60 separately.

[Rich Hathaway]

You can use the below command to set N66 only for slot 5
I don't think your mr5100 can see N60
AT!BAND=05,"5G_N66",0,0,0,0000000000000002,0,0

You don't have to have all the 0 in front of the 2 but it will load either way.
This is likely the same cmd dc is running

[LadyAskme]

Thank you for your reply. I sent the m5100 back to the seller it lacks on many missing bands/unsupported
so I will be purchasing the M6500 pro instead I will keep you posted.