1- How do I setup as a Client to a Wifi hotspot and pass the Internet to the ethernet ports? (WE826-T2 w/ Goldenorb 2018_11_3)
2- How do I setup a Cell Service in and Wifi and Ethernet out?
I'm a beginner in router config. Thank you!
How to setup as a Client to a Wifi hotspot
Forum rules
Please assure there is not an existing forum and topic related to your post
Please assure there is not an existing forum and topic related to your post
-
BillA
- Posts: 1230
- Joined: Sun Dec 01, 2019 6:46 pm
- Location: USA
- Has thanked: 219 times
- Been thanked: 327 times
- Contact:
Re: How to setup as a Client to a Wifi hotspot
Not sure if the WE826 router can be used as client connected to a hotspot in order to output its connection through ethernet, but here's another cheap solution.
You could use a WiFi to ethernet converter such as the GL-iNet MT300N (https://www.gl-inet.com/products/gl-mt300n-v2/) to convert a hotspot's connection to ethernet. First you would change the mode on the MT300N's to bridge/pass-through, connect to the hostpot, then simply connect its LAN ethernet to a router or whatever else you want. For additional features you could reflash the MT300N with OpenWRT or GoldenOrb firmware.
You could use a WiFi to ethernet converter such as the GL-iNet MT300N (https://www.gl-inet.com/products/gl-mt300n-v2/) to convert a hotspot's connection to ethernet. First you would change the mode on the MT300N's to bridge/pass-through, connect to the hostpot, then simply connect its LAN ethernet to a router or whatever else you want. For additional features you could reflash the MT300N with OpenWRT or GoldenOrb firmware.
