WG3526-P w/ EM7565 Speed issues

[Ace027]

Ok, please bear with me since this is my first forum post EVER.

I installed a WG3526-P router with an EM7565 modem in it. I hooked up two standard Wilson wide-band directional yagi antennas via two 10ft LMR-200 coax cable from the thewirelesshaven.com store to the router. I followed all the guides outlined in the description of the router on the The Wireless Haven store. I got the modem and router up to date on firmware and installed the latest WiFix software. I have the antennas mounted on a pole screwed to the highest point on my house, but I am only getting 10mbps. Note: I am only 9 miles from the tower. This wouldn't concern me as much if I didn't have a mofi4500 v2 installed at my uncle's house (same property) with an antenna setup that is quite a bit lower to the ground. The mofi is getting 80mbps!! It is really bothering me that the mofi is outperforming the WG3526. Below are screenshots of the gstatus of the modems. Any help would be greatly appreciated.

[Didneywhorl]

Right off the bat, you have a cabling or connector issue. Your PCC and SCC1 RxM to RxD should not be that far off in number. It looks like your Div antenna connector is either grounded or slightly popped off.



Your Main connection looks great in signal level, but the issue with the connectors making a SINR of 2.4 shows you have CRAZY noise. Ill bet a connector is shorted to ground or something

[Didneywhorl]

Notice the MOFI has similar RxM and RxD RSSI levels and a super clean SINR of 16.6.

You want the Signal to Noise ratio of 12.5 or higher if possible. under 7 is bad. 2 is WAY bad.