Wireless Joint

Didneywhorl wrote: ↑Mon Aug 29, 2022 7:38 pmNope.

Any suggestions, since I determined that the jumper is installed?

Didneywhorl wrote: ↑Mon Aug 29, 2022 10:06 am WG1608-Watchdog-Jumper.png

If this 0 Ohm resistor isn't there as a jumper, then you have the hardware watchdog turned ON. If the resistor is there, you're good.

Just confirming I have the 0 Ohm resistor.

Attached is an updated system/kernal log... recently disconnected... Seems to be condensed and easier, perhaps to find issue.

Thank you

Hi,

Thank you for the update, is there a way to check through the router settings to see instead of having to open the unit?

Thank you

Didneywhorl wrote: ↑Mon Aug 29, 2022 9:36 am There may be a hardware watchdog present that is not seeing the connection, causing the wan0 to ifdown/ifup.

Does your wg1608 have the watchdog enabled?

Hi,

Thank you for the reply, may I know where I need to go to locate this "watchdog"?

Thank you

Hi everyone! I'm running a ZBT-WG1608 (16M) / MediaTek MT7621 /GoldenOrb_2022-08-25 (OpenWrt 21.02 SNAPSHOT I have been doing some searching on this forum and could find nothing that might be comparable to my issue. I love to tinker when it comes to technology, however I am no technology specialist ...