Wireless Joint

Alright, switched from verizon f/w to generic AT!ENTERCND="A710" AT!IMPREF="GENERIC" and solved emm state issues, reflashed router a couple times, and ive got internets again!! I hope this thread of me fumbling around learning might help some other noob someday. Thanks all Untitled.png

Think I figured it out, saw the name of modem in windows said qdloader, realized it somehow got stuck in qd loader mode, not sure what that is or why it happened, but I reinstalled modem drivers a few times, installed generic and then verizon firmware a couple times per Jims tutorial (https ...

When logged in via SSH, what commands are you sending to be able to send the AT commands to the modem? Also what roddel007 said :) I tried upper and lower case to no avail, all responded with NOT FOUND ATI AT!ENTERCND="A710" AT!RMARESET=1 AT!RESET got usb dongle in mail today, installed sierra ...

Didneywhorl wrote: ↑Tue Nov 10, 2020 10:09 am You can putty into the router directly without a usb device. Just use the routers ip address and your web UI password. Send the RMA reset command there.

thanks, entering AT!ENTERCND="A710" AT!RMARESET=1 , both respond with ash: not found
is there a specific directory to enter in?

https://wirelessjoint.com/viewtopic.php?f=12&t=1964 thanks for the tip, still not working, i did the following -reflashed router with sim/modem removed using firmware recovery method -reflashed router a few times using web ui -restarted -ran AT!GSTATUS? still returns "Can't open device /dev/ttyUSB1 ...

Hello all i am using a Em7565 inside a WG3526-P it has worked fine for the last 2 months, woke up the other day to no internet, clues are as follows -debug is spamming "/dev/ttyUSB1 Can't open device /dev/ttyUSB1" -connection log shows the modem just disconnected itself in the early am -All AT ...

You likely went over the hotspot limit. Do you have ipv6 TTL(HL) set as well? THANK-YOU! That fixed it, needed to set the ttl (hop limit) for ipv6 NETWORK>FIREWALL>CUSTOM RULES Added these two lines right before #endTTL ip6tables -t mangle -I POSTROUTING -o wwan0 -j HL --hl-set 64 ip6tables -t ...

You likely went over the hotspot limit. Do you have ipv6 TTL(HL) set as well? im not sure, i set it with the interface network>firewall>custom ttl so today i find that my phone on wifi for some reason is only connecting ipv4 and has a stable connection, whereas my pc is connected both ipv4 and iv6 ...

Good afternoon, First and foremost, big thumbs up to you guys this site is my new hobby :D I recently purchased a Sierra Wireless EM7565 Modem and WG3526-P from the store along with the necessary parts. Thanks to all of JimHelms posts, the Install went great and was rocking better internet than my ...