Wireless Joint

if still having problems you can try my version of ROOter that i build.
based of the latest snapshot kernel 6.6

i have WG1608 v1 16MB so if you have any version higher .i do not have the watchdog timer running because my version does not have it

https://drive.google.com/file/d/1CvA ...

I'm posting my ROOTer firmware with a working 2.4g & 5g WIFI. I went outside my house about 100ft from the room the router was located and was able to connect to the 5G WIFI. MWAN3 needs to be configured to show information on the overview webpage. I did not test to see if the MWAN works. I did test ...

so i guess if you uninstall the firewall app under system===>software===>installed then click remove it will try to remove the firewall even though it can't because its part of the firmware. it fixes the problem and the router works even after a reboot.

@dairyman

I got 2.4GHz and 5GHz working on the WG1608/WG3526 running the OpenWRT 19.07 Snapshot with the help of LGA1150 on the OpenWRT forum. I installed the snapshot over the top of the WG1608-GO2020-06-14 firmware, but that wiped out the Modem section in the GUI. What was needed was to use the ...

well i use a homebrew gateway/router. with ClearOS 7.7

1- HP Z420 with E5-2670 v1 CPU, 32gb memory, crap msi 6800 graphics card & PNY 240gb ssd (system about $299)
2 - HP NC523SFP DUAL PORT 10Gb network cards. ($25 per card on ebay used)(one 10gbe port is used for my comcast 1gb connection with an ...

try setting a full static ip address on your network card.

ip address: 192.168.1.100
subnet: 255.255.255.0
default gateway: 192.168.1.1

preferred dns: 192.168.1.1

if you are using winblows. dhcp gets confused and does not pull the address

i have actually had to do a couple of hard flash resets ...

do not waste your money on a wg1608. i have two of them and both do not work properly. either the internal LTE modem crashes and then you have connection problems. then to top it off the 5ghz wifi does not work at all. no one wants to seem to make a working firmware for it. so i am basically stuck ...

@ALL

Does anyone have a working version of Goldenorb that has 2.4ghz and 5ghz wifi working for the WG1608 router?

Hi all -- thanks for the help thus far!

I've got a WG1608 here with a Sierra EM7565. Came with OpenWRT pre-installed, but was incompatible and modem tab didn't show up. Flashed to GoldenOrb WG1608-GO2020-06-14, found modem tab. Put in APN and other settings as per FAQs (thanks) and still no go ...

@dairyman

I got 2.4GHz and 5GHz working on the WG1608/WG3526 running the OpenWRT 19.07 Snapshot with the help of LGA1150 on the OpenWRT forum. I installed the snapshot over the top of the WG1608-GO2020-06-14 firmware, but that wiped out the Modem section in the GUI. What was needed was to use the ...