Wireless Joint

I have a Cradlepoint CBA850 with a LP6 modem. I have 2 700-2700MHz 15dBi 4G LTE Directional Antenna (Linear ± 45°) antennas and use AT&T. Band 4 is pretty bad for me and when my modem connects to it, my speed drops significantly. Can I program using CLI to LOCK OUT B4 ? Or would I be better band l ...

* In regards to your signal strength though you might have to go to a signal booster. Don't buy the cheap Chinese ones. Not worth the money. You can find a rundown on the best boosters over at https://www.ubersignal.com/4g-lte-signal-boosters *Doing some searching I see that you can not set TTL in ...

Viper67857 wrote: ↑Fri Jul 17, 2020 2:04 pm Also, do you have the modem in an enclosure up there with the antennas or do you have a long run of cable? Long runs give a lot of loss, especially if it isn't lmr400.

Thanks!
My modem is at the end of about 25' of LMR400.
How do I lock out B4 on this modem?

Numbers don't look good for reception. Being AT&T you most likely would want to have Band 12 as your primary LTE band. One thing I have a question about is what AT&T plan are you running? Also do you have a TTL value set on the Cradlepoint? You might have to repoint your antenna until you get in ...

How high have you mounted those antennas and have you fine tuned the angles for max signal? Your signal strength, even on the 'good' end, is barely usable... Yes, I have spent a lot of time on the roof. The antennas are about 35' up. That's the best I can do. Would there be any benefit trying to ...

I have a Cradlepoint CBA850 with a LP6 modem. I have 2 700-2700MHz 15dBi 4G LTE Directional Antenna (Linear ± 45°) antennas and use AT&T. My internet significantly waxes and wanes all day. I get max speeds of about 25Mbs all the way down to <1.0Mbs (or nothing). Though 25 is not great, it's probably ...

I have 2 sims installed in my LP6. I have a couple questions: Is there any quick way in the GUI or console to switch back and forth between the SIMS? I'd like to use "smart WAN selection" to switch between SIMS when the d/l speed drops. AFAIK, I can trigger with latency, jitter and signal. Any ...