I also see unsupported protocol type on wan2 when the sims are swapped and fail load balancing.

I have successfully enabled load balancing on build GoldenOrb_2018-07-24 OpenWrt 18.06.0-rc2. I have also encountered a few interesting quirks that don't make any sense. The 2 providers I am load balancing are sprint (calyx) and att (tablet sim). After much troubleshooting, the real solution I found ...

Thank you for info about the killall issue Jim. I will dig in the rooter forum to see if any solutions are presented. I did try "Enable Load Balancing at Connection" checked on/off for both modems at the time on GoldenOrb_2018-05-24 with 2 mc7455's. One variable that I wanted to make sure was that ...

New problems have popped up after following the of modems and men load balancing guide. If I plug in the usb modem adapter while the WG3526-P is powered on, the router will pick up the 2nd modem, but after a few minutes the 1st modem will go into a reconnecting loop. (both modems work fine ...

Thank you for the input. I was not aware the usb on the WG3526 was capable of hosting another modem. I will purchase the necessary parts and try this route.

I have encountered a hiccup on my plans of 1:1 load balancing 2 isp's on two WG3526-P routers.

I planned to piggyback from router 1 lan to router 2 wan port and then run one ethernet cable to in house switch. Since the Wan port must be used for poe, does this make load balancing by this method ...