Sure np, I hope you backed up sbl before you deleted it.

Codes for this cannot be calc yet but security can be bypassed and openmep can be enabled

will be nice to have keygen working to

I got a couple of these a few days ago, they are nice but have some updated securities so it is a work in progress.
Please add to this thread anything you find about it.
I was able to make up an spk loaded thru fdt and also make some custom firmware for it to be loaded thru fastboot.
it has a 40 ...

OK update since yesterday I have now got then imei written (hard code only)
Now need to make some de-throttle files for it, it runs about 220mbps on tmobile here without dethrottle so
lets de-throttle it and see what it can do.
here is a vid showing the gal s22 imei I put on it and it running on ...

Please stop the emails and messaging about this, here is the file I modified it with AKOSTERIN's commit it is temporary and does not have SDX65, I only added SDX75 to it to test with it so you should go to bkerlers git page and get the complete file
once edited by him.
I put that in the comments in ...

AKosterin wrote: Sun Mar 16, 2025 5:03 pm my pull request to sierra keygen with !OPENLOCK and !OPENCND keys

security challenge working with your commit-good deal-

The tmo firm is not unlocked, if it were the apn would change and you would get service when you put in a verizon sim card which does not happen.
I can load vzw firm on it for you that will unlock it. there is no public version of the firmware or leak of it that I have seen.
I have Verizon, T-Mobile ...

For fastboot on netgear remove the battery and cable then hold the reset button on the back and slide the battery in first and continue to hold reset in and plug the cable in then keep holding reset until your pc dings, about 5 seconds or so.
If it will go to FB I can prob recover it for you, if not ...

put it in download mode and reload it, if it will not go into dl mode you will have to load it from fastboot mode.

Ok, I assume you only want the root file system, this is a 3 volume file containing, cache, usr and root filesystems, here is the rootfs part.
If you take it please hit the thank you button

debrand/rebrand MR7400
All of these startup and shutdown logos can be modified
In this video I used the spots where the at&t logo and the spinner logo were.





https://youtube.com/shorts/VZepEYvbbU8?feature=share

Someone sent me this device to look at and since I just did the T9 I took a look at it.
It is basically just a t9 with a slightly bigger screen and a slightly diff board layout but almost the same
It is so similar I loaded t9 firmware to it and it runs fine with it.

You can see here my clone of t9 ...

Where can i get ahold of the t9 firmware you are using?

It is not a public file, I have not posted it anywhere.




have you tested it?


Not really, I made it for the T9 and have tested it on that device fairly well but did not do much if any testing
on the T10 besides loading it and ...

make a raw dump containing the spare and use that for the t10, as long as your nand registers and nand controllers are correct it will should load and run fine, however , be smart and first make a backup of the t10 in case it goes wrong so you can at least get back to a working device.

I had not planned on it, that would lead to about a thousand emails and msg's for support for all the people that mess their devices up fooling with it. cross flashing is very risky and I did not test this at all other than letting it run for a day, I have not even picked up a t10 since that day.

I gained my root access thru the adb port so I never needed the root pass so I never bothered to decrypt it, try frk9x07
that was it for the t9 and this one has the same chip so it may work. if it doesnt you can decrypt it by brute force use md5crypt to do it.

why dont you post it here and let the community try it, have you checked to verify it is md5crypt?

I am the owner of autoverifyme.com the original sms verification service, we used real USA numbers not virtual numbers, it became to difficult to get numbers for us so we took it down. we still have the tool though. virtual numbers would never work to verify most of the services our clients needed ...

autoverifyme worked for several years and besides my iphone tool it made more income than any tool I made, it had about a million lines of code, we used cdma phones and had about a thousand of them, the client would buy x amount of lines from us we used pageplus mostly but some vzw direct also ...

I had worked on getting a legit contract from Verizon for a year, we had the details ironed out and they were going to sign in a week we were going to be partners then all the sudden they did a 180 the next week they implemented into their system to only allow 3 MDN changes per cycle and told me ...

We could talk about it but as is it will not work now it is coded for use with a cdma network like vzw used to be, now having said that we did make a hack that allowed gsm lines to be programmed to cdma devices I am not sure if it still works its been like 3 years since I have tried it, you can msg ...

You can use my firmware to load on it, it has comports already enabled including the android port which has full root access.

I did it via emergency mode and reload modified firmware to it with ports enabled. Otherwise you would need to have the correct url and password to do it like the t9, its been a long time since I fooled with it but I believe they are crypted now in the t10

look for testpoint on the board