Wireless Joint

This is not the place for troubleshooting your modems and routers, please post in the appropriate support location.

The parabolic mimo grid at The Wireless Haven has the most gain on those bands. Your signal is already decent enough, though, so a cheaper mimo panel antenna should suffice.

I was comparing my cellphone with the modem, and as you stated before, both hardware are completely different and my cellphone is amp to catch signal in a very weak environment also it's not intended to use external antenna, where the

This is true. Some time ago when I bought my first LTE modem ...

I know cause these are what worked for me

TTL 64 or 65 seems to work with T-Mobile ok at this time. It doesn't hide the data use with just TTL it just lets you use it like it's a phone (not hotspot). For T-Mobile anyway they text me a warning with over 50gb of data use (phone use or not) and "can" throttle me during peak hrs/congestion (I ...

Verizon ttl 64
Atnt/FirstNet ttl 65
Visible need to set as follows

#start TTL rules
iptables -t mangle -I POSTROUTING -j TTL --ttl-set 64
iptables -t mangle -I PREROUTING -j TTL --ttl-set 64
ip6tables -t mangle -A POSTROUTING -o wwan0 -j HL --hl-set 65
ip6tables -t mangle -I PREROUTING -i wwan0 -j ...

yea verizon slows me down from 6 am to 3 pm after that its full lte

Using OpenWRT firmware like GoldenOrb or WiFix.

You should be setting the TTL under Network > Firewall > Custom Rules

See this post on tethering: https://wirelessjoint.com/viewtopic.php?p=10303#p10303

Prvt.N00b wrote: Fri Jan 22, 2021 6:18 pm I fixed this problem by doing a Modem Firmware update using the sierra wireless support page.

That's interesting. I wonder what might've changed to require the firmware update. Sierra also has Tmobile specific and approved firmware now too, for the EM7565.

Could you please share - how did you change device ID in your modem? Thank you.


WE don't share that info on this site. Too many international laws on device identity changes to risk getting the forum shut down.

But you can Search the googlewebz for Sierra and keygen and .py and how to use it ...

Most likely the phone will be based on better modem and antenna setup.

Usually they both have similar signal getting capabilities. The modem and number of internal antennas seems to play the largest role. I think at least.

Saw this post once again and this research intrigued me

Can you connect the phone to the router and SSH into the router using putty and run the following command:

ifconfig -a

Need to see what interface is being assigned to the USB phone. Look for the interface that shows IPV4 and IPV6 addresses.

I do not have a gi.net to test but, and looking at ...