Wireless Joint

Hello,
My aunt and uncle had fixed fixed wireless service and high winds blew down the tower they got service from. She had just had surgery and is confined to the house with no internet now. The only good cell service they have is verizon and the unlimited plan is gone now. Seen this post where it ...

AT! Commands for setup:
Run each one at a time waiting for ok.
at!entercnd="A710"
at!usbcomp=1,1,1009
at+cgdcont=1,"IP","VSBLINTERNET"
at+cgdcont=1,"IPV4V6","VSBLINTERNET"
at!reset

After that make sure apn is VSBLINTERNET.
If it isn't type it in there and save.

Then set TTL to 64 and save and ...

Hello,
Did this awhile back. No longer using it with a MC7455 my uncle is now using it in a nighthawk m1. Which is capping him to 5mps. But that works for him.
So honestly don't know.
Here is a post from the guy that started this.
https://wirelessjoint.com/viewtopic.php?f=10&t=653#p4057
Only other ...

No success yet.

I did the following:
1. Installed the MC7455 into the WE826GO-U
2. Booted the router and applied the following AT commands:
at!entercnd="A710"
at!usbcomp=1,1,1009
at+cgdcont=1,"IP","VSBLINTERNET"
at+cgdcont=1,"IPV4V6","VSBLINTERNET"
at!reset
3. Confirmed that APN was set to ...

That looks ok. Very interesting. Going to try it myself and see what happens. Will report back my results.

Out of curiosity, what do you see when looking at Network / Interfaces? Do you get an IP4 assigned or does it look like this:

KQ4TYML[1].jpg

Also do a at!gstatus? and post results.

You ...

I got Visible to work with Quectel MC25-AF but I have not tried the EP06-A. Visible seems picky about the modem and/or IMEI. I've tried two MC7455, one works, the other does not. Visible does not work with a Telit LM940. Overall, I seen many more modems that fail to connect than ones that work. Try ...

foolhardy wrote: Fri May 29, 2020 7:17 pm Unfortunately, no data will load so I cannot do a speed test, even through apps.

Darn, was hoping for better news. Will try mine this weekend.

hbr245b wrote: Fri May 29, 2020 9:42 pmSierra EM7565

Wonder if Visible starting to block MC7455. Heard of Verizon blocking Mofi units which are MC7455.
Visible is owned by Verizon. Maybe terryjett will try his and see if it works or not.

To bring my post back on topic, my mofi has a MC7455 (I think - it's not powered on currently so can't check). The visible sim works in that too just by changing the APN name.

Maybe I should just buy a different modem? Currently I am unsuccessfully trying to get working the WE826GO-U with MC7455 on Visible.

Hello again,
Don't know if this matters at all. Sounds meaningless but what the heck. The only difference between the mofi and yours is the mode you are in. The ...

Not sure the topic you speak of, but without the type of modem your info has no bearing.


The topic in question is MC7455 & Visible. I just did not know what modem I had.

I can confirm that my Mofi has an MC7455 and Visible works fine by selecting the correct APN from the drop down list and ...

I re-read the thread and noticed that your MC7455 has a different firmware to mine:

0:[AT!impref?]
1:[!IMPREF:]
2:[preferred fw version: 02.30.03.00]
3:[preferred carrier name: GENERIC]
4:[preferred config name: GENERIC_002.046_001]
5:[current fw version: 02.30.03.00]
6:[current carrier name ...

foolhardy wrote: Sat May 30, 2020 10:10 am My apologies. I meant "Where did you get your firmware which you installed recently on your MC7455?"

The mofi web interface has an "internal module flasher" to update modem firmware. Presumably the firmware is downloaded from mofinetworks.com but I can't be 100% certain.

You could try the Verizon firmware. Is it already loaded in your modem? I'm not certain it will have any effect though.

Just to re-iterate: I haven't run any AT commands to make changes to the modem. I just set the correct APN via the web interface & rebooted. Generic firmware selected on the modem.

I ran the following commands on my modem to try to get it to work with visible:
at!entercnd="A710"
at!usbcomp=1,1,1009
at+cgdcont=1,"IP","VSBLINTERNET"
at+cgdcont=1,"IPV4V6","VSBLINTERNET"
at!reset
Might that be causing me problems?

Hello got this from home Sierra wireless MC7455 tutorial ...

For those who are still having difficulty connecting on Visible, from what I've read they work off of IPV6 only, so try this which will also set it to auto-scan and LTE only. You may also have to try both QMI and MBIM modes.


AT!ENTERCND="A710"
AT!BAND=00
AT!SELRAT=06
AT!CUSTOM="IPV6ENABLE",1
AT ...

I get:

AT!BAND=00
ERROR



Seems like you might be having a composition issue, try both both modes.
I would reset the modem first then send the rest of the commands.

AT!ENTERCND="A710"
AT!RMARESET=1
AT!RESET



MBIM mode
AT!ENTERCND="A710"
AT!USBCOMP=1,1,1009

Wait a few second then enter ...

Yes I did with Torguard.

I purchased it from The Wireless Haven about a month ago.

I have successfully updated firmware to GoldenOrb_2020-05-16 and the reboots persist.



There are a couple of possibilities for the rebooting.
The most common is an under powered router due to a weak or failing power adapter, so try a ...

I have a one month old WE826-GO that seems to reboot itself randomly. I use LTE for internet, via MC7455, and it is not that the internet disconnects, but the router reboots. The WiFix network is not visible from PC for about two minutes and then when the WE826-GO boots back up it reconnects ...

I tested this in non-WiFiX firmware, just rooter. It seems to be the same. May want to ask the Goldenorb guys over on the whirlpool forum.

https://forums.whirlpool.net.au/thread/ ... =-1#bottom