Wireless Joint

It's taken a few months and much assistance from BillA, but I'm happy to report that I've successfully gotten PagePlus working with my setup

https://i.imgur.com/2beoFmi.png

Ultimately I believe what solved my issue was following Yipzy's advice to disable autoselect config on SIM detection and ...

Don't think this is to bad of a price for non POE. Could update modem later when it arrived.
https://www.ebay.com/itm/ZBT-WG3526-LTE-Router-w-Quectel-EM06-A/254683586407?hash=item3b4c531f67:g:ohYAAOSw-9leZ6bQ


I've purchased a few of these from the same seller since the The Wireless Haven store ...

This may or may not help, but when I had similar issues, Yipzy's advice sorted me out:

https://wirelessjoint.com/viewtopic.php?f=19&t=1289&p=10327#p10327

I ran these commands and then rebooted the router and then input the APN again (through the UI)

AT+QMBNCFG="AutoSel",0 (stop Autoselect ...

Thanks for taking a look I'll monitor the thread

Going to give this a try in the AM and report back. Thank you for tackling that so quickly.

Well I solved the issue.. SIM card upside down. I checked the three CME errors and noticed they are all related to the SIM card and also saw this post from yesterday which is an identical router throwing identical errors.

To clarify, the SIM card contacts (gold side) need to be facing down.

Thank ...

After the restore the EP06 isn't recognized; shows no modem present under Network Status. The only place it comes up is under Debug Information below the AT command box. Whenever I directly install the EM20 it is recognized however I get the same three CME errors 3/100/14.

Also this is a different ...