Wireless Joint

Hello all, I just found this long thread about the wide band parabolic grid. I work at the design and fabrication shop and lab where it originated and can answer any questions. How can I help?

SliverGT wrote: Fri May 01, 2020 10:57 am Is this antenna still available? I don't see it on The Wireless Haven Store.

They are currently out of stock. Have a new shipment on order and will be here mid month.

I'm currently playing with the 4x4 mimo flat panel. Its a fantastic unit. I'm not far from my tower, but it technically is better tuned than my pair of dual mimo narrow band 15dbi antennas. I have it connected to a weatherproof enclosure via 4 5' LMR200 cables. More testing to come.

I'd recommend using the Raspberry PI foundation PoE hat. The latest version, the first versions had some bad bugs.

After posting I dug around the net a bit and all of the logs I could find showed the same result. Seems when you are in 5G mode you will not see readings on the last 2. Switching to 4G mode and all show as normal. Not sure if this is a firmware/modem issue or if it is just the fact that these modems ...

Keep the info coming, this is so dang cool!

OK, I'm a noob here, so take my input with grain of salt. Not sure 2 minutes is long enough for a modem to settle on the best possible combination of bands at each location. You might think about giving it 10-15 minutes before doing any testing, then run a few tests before moving on. Yes, CA is only ...

... Here's my questions:

Should I reset the modem after changing the heading (AT+CFUN=1,1) or will the modem settle on a new better cell eventually by itself? I want to avoid having the modem stuck to an inferior but useable cell because then I won't have accurate metrics for that heading ...